Creating and Starting a Test Case
Ethernet and Fibre Channel Application
85
Ethernet EtherSAM (Y.1564) and RFC 2544 Dual Test Set Test Cases
Create the test on the local module as follow:
1.
On the local module, proceed with the test creation as described
above (starting with step 1 on page 81) at the exception of the
following parameters:
1a.
Select the desired
EtherSAM (Y.1564)
or
RFC 2544
sub test(s). All
sub tests are selected by default.
For
RFC 2544
:
Throughput
: Gives the maximum throughput of the device under
test for which there is no frame loss. Refer to
page 304 for more information.
Back-to-Back
: Gives the maximum number of frames that can be
sent at maximum throughput. Refer to
for more information.
Frame Loss
: Gives the percentage of frames that are lost. Refer to
on page 313 for more information.
Latency
: Gives the time required for the sent frame to go through
the device under test. Refer to
information.
For
EtherSAM (Y.1564)
:
Service Configuration Test
consists in sequentially testing each
service. It validates that the service is properly provisioned and
that all specific KPIs or SLA parameters are met.
Service Performance Test
simultaneously validates the quality of
all the services over time.
1b.
For
Dual Test Set
Mode
(see step 1e on page 81), select the
Local
test mode.
