Creating and Starting a Test Case
90
IQS-8500 Series and IQS-8120NGE/8130NGE
Ethernet RFC 2544 Test Case
To create an RFC 2544 test case:
1.
Test configuration:
1a.
Select
Ethernet 10/100/1000
or
Ethernet 10G
as the
Interface Type
.
Interface Type
is not available with
IQS-8510G.
1b.
For IQS-8510B: Select the
Topology
test
type:
Single Port
or
Dual Ports
.
1c.
Select
RFC 2544
as the
Application
Type
.
1d.
Select the desired RFC 2544 sub test(s).
All RFC 2544 sub tests are selected by default.
Throughput
: Gives the maximum throughput of the device under
test for which there is no frame loss. Refer to
page 304 for more information.
Back-to-Back
: Gives the maximum number of frames that can be
sent at maximum throughput. Refer to
for more information.
Frame Loss
: Gives the percentage of frames that are lost. Refer to
on page 313 for more information.
Latency
: Gives the time required for the sent frame to go through
the device under test. Refer to
information.
1e.
Leave the
Dual Test Set
check box cleared. For Dual Test Set test
case, refer to
Ethernet EtherSAM (Y.1564) and RFC 2544 Dual Test
1f.
Press
Next
.
