Running DSL/IP Tests and Viewing Results
88
MAX-630G
DSL/IP Connection Summary
DSL/IP Connection Summary
The
Connection Summary
tab allows you to view the pass/fail status and
details of the test results.
When the
Test Interface
for
Auto Test
or
Manual Test
is set to ADSL2+ or
VDSL2 bonding mode, there will be 2 columns of results. While the test is
running, 2 soft LEDs will appear above these columns displaying the 2-DSL
line condition. The pass/fail status is based on the 2-DSL line connection
state and combined data rate. Once the test is completed, these 2 soft
LEDs disappear and the pass/fail icon is displayed at the top of the screen.
Profile
displays the name of the current profile
that results were saved to. You can change the
Profile
within a test once it is stopped. Pressing
the up arrow key opens a list of profiles from
which you can select. Use the on-screen function
buttons to navigate,
Select
a new profile, or
Cancel
and restore the test result screen.
Sync Time
is a count-up timer (maximum 99 h)
that starts counting only when the
Line Status
reaches
Show Time
. In the case of bonding, both
lines must reach
Show Time
before the counter
starts.
Line Status
displays the status of the line under test during negotiation
with the DSLAM. The value changes from
Idle
/
Activate
/
Handshake
/
Training
/
Show Time
for ADSL2+ or VDSL2 mode.
Note:
When loading firmware into the Broadcom chipset, the
Line Status
value
displays
Loading M:SS
, where M:SS is a count down timer.
Operation Mode
is the xDSL mode of operation, bonded or
non-bonded, as negotiated between the unit and the DSLAM.
Downstream
/
Upstream
SNR is a value ranging from 0 through 63.5 for
the existing SNR (signal-to-noise ratio) margin.
