Copper Auto Tests
224
MAX-610
POTS Auto Test
POTS Auto Test
The purpose of the
POTS Auto Test
is to detect the loop current and
measure the voice frequency parameters in a copper telephone loop. This
test allows you to compare measured results against stored threshold
values to provide pass or fail status results of the POTS circuit type.
To access POTS Auto Test:
1.
From the
Copper Main
menu, use the up/down, left/right arrow keys
to highlight
Auto Test
and press
.
2.
Highlight
POTS Auto Test
and press
to start the test.
Summary
The
Summary
page displays detailed results of the
loop current,
Power Influence
and voice frequency
measurement values, pass/fail status, and parameters.
POTS Auto Test
consists of a combination of multiple
tests.
Current Group
is the current test group name, for
example
Auto Test
.
Current Test
displays the test being measured.
Here you can switch to another test from the given
list. However, this action will terminate the
ongoing measurement test.
VF Noise Filter
displays the voice frequency noise filter used,
dependent on
ITU
or
ANSI
Standard
mode and Noise Filter set in
Setup
/
Application Settings
.
