Multimeter Tests
MaxTester Copper Test
99
Current
Current
The
Current
test allows you to measure the AC/DC currents and frequency
in the loop.
Snapshot
The current
Snapshot
shows measured AC/DC results
for each lead combination. The parameters are as
follow:
Current Group
is the current test group name, for
example
Multimeter
.
Current Test
displays the test being measured.
Here you can switch to another test from the given
list. However, this action will terminate the
ongoing measurement test.
Selected Pair
allows you to select
All Pairs
or a
single wire pair for measurement.
Termination Resistance
is a read-only value of
430
Ω
that defines how
much resistance the tester uses to connect to the line.
Threshold Settings
button opens a new page that allows you to set the
AC/DC current thresholds for each pair.
Result
displays a snapshot of the pass/fail status, DC current, AC
current and frequency (Hz) results for each selected wire pair.
Test Status
displays the current state of measurement or an error
message.
