SmartR™ Features
MaxTester Copper Test
129
Pair Detective
Multimeter
The Pair Detective
Multimeter
page displays read-only
results and the
P/F
(pass/fail) status for the following
tests:
DC Voltage
displays the volts for each DC
Pair
.
DC Current
displays the
DC
current results for T-R
wire
Pair
.
Capacitance
displays
Capacitance
and
Length
for each wire
Pair
as well as
Capacitive Balance
among
All Pairs
in
%
.
Isolation
displays
Resistance
and a
Soak
Counter
for each wire Pair.
TDR
The Pair Detective
TDR
function allows you to run and
edit the TDR test. The test runs continuously for the
selected parameters after the first cycle of the Pair
Detective test. After saving the results, the Pair
Detective results will contain the
Estimated Length
value as found for the first cycle of the
Pair Detective
test.
The
TDR
test displays the line trace and is
continuously on and ready to use. It displays and
updates results in real time, in either
Portrait
or
Landscape Mode
, until you stop the test. The last
valid results then remain displayed.
Current Test
displays the test being measured.
Range
allows you to set the range from the given list.
Gain
allows you select the gain test parameter from the given list.
