Getting Started
24
QA-805 and W2CM Interface Module
Turning the Unit On/Off
Turning Off the Unit
To safely turn off the QA-805, please ensure the following steps
are taken:
1.
Stop all test applications and save results to prevent measurement loss.
2.
Power down the Processor v1(AM4020M System Controller) by pulling
out the HotSwap switch to its first click position. Wait until the Blue
HotSwap LED stops flashing and turns Solid Blue to indicate that the
System Controller has shut down safely.
3.
Power down the Hard Drive(AM4500) by pulling out the HotSwap
switch. Wait until the Blue HotSwap LED stops flashing and turns Solid
Blue to indicate that the Hard Drive has shut down safely.
4.
Power down all active power supplies.
Turning On the Unit
To safely turn on the QA-805, please ensure the following steps
are taken:
1.
Ensure that all empty slots are filled with the appropriate sized Filler
Card/Air Baffle.
2.
Ensure that the HotSwap switches on both the Processor v1(AM4020M
System Controller) and Hard Drive(AM4500) are fully pushed in.
3.
Power up all required power supplies.
Summary of Contents for Quality Assurer QA-604
