EXHOBBY 768-1, User Manual

ROG(Rise off Ground) Take off

and takeoff easier. Slowly advance the throttle, adding rudder correction as needed to keep the model rolling 

gentle climb.

controls as necessary to establish a gentle turn away from the runway.

If  the  controls  respond  erratically  or  if  anything  else  seems  wrong,  make  certain a ll  the  servo w ires  are 

securely  connected t o  the  receiver  and  that  the  transmitter  and r eceiver  batteries  are  fully  charged.  If  you 

After the range check, fully extend the antenna.

getting  low  you  will  usually  notice  a  performance drop  before  the  ESC  cuts  off  motor  power, so when you 

motor cuts off by holding the throttle stick all the way down for a few seconds.

the alarm sounds you should land your model

.

Perform a Range Check

performing a range test is a good way to detect problems that could cause loss of control such as low batteries 

defective or damaged radio components or radio interference. This usually requires an assistant and should be 

First turn on the transmitter. Then, install the fully charged battery into the fuselage and hold it in place with the 

hook-and-loop strap. Connect the battery and install the hatch.

causing damage or injury.

With the antenna on the transmitter collapsed (not extended ) , begin walking away from the model operating 

the controls in a predictable pattern (for example: Up, then down elevator. Right, then left aileron. Right, then 

left rudder). While moving the control surfaces, also vary motor rpm.

Have your assistant alert you if the controls fail to respond or if they move suddenly or erratically. You should 

rotate

10 mph [ 16 kilometers /hr].

 Be certain the ailerons , elevator and rudder respond correctly and that none 

of the controls have inadvertently become reversed.

If the surface is smooth ( such as paverment or blacktop) the plane can take off from the ground. But most

Take off