EAC Transceiver:
Installation Guide
981-000046-000R1.05
1
CONNECTIONS
NO
USER DEFINED
RELAY CONTACTS
GND
LISTED CAT 5E
FROM DOOR SWITC
COM
3A/30VDC RESITIVE
EAC TRANSCEIVER
24VDC 300MA
250VA PWR LIMITED
SELV SUPPLY
NOTE: 307.2 kHz EXCITER
INDUCTORS MOUNTED
ON PC BOARD
GND
1
2
3
4
5
6
7
8
RS485 +
433.92 MHz RECEIVE
ANTENNA
RS485 -
DOOR SW
RS485 NETWORK
+Vin
eAC System components are designed to meet the requirements for Class 2 circuits operating from a
non-hazardous secondary power source limited to 240 VA. Cabling materials must be selected for the
installation environment in accordance with the applicable jurisdictional codes.
2
INSTALLATION
MOUNTING INSTRUCTIONS
The Controller chassis may be horizontally or vertically mounted on a wall, ceiling, or shelf as long as the
front face panel is easily accessible. The RX antenna should be positioned on a vertical plane for
maximum performance.
The detection field radiates from two internal orthogonal ferrite cored inductors. The field must fill the
area in front of the door all the way to the floor so that no Tag can reach the door without being detected.
SATELLITE EXTENSION
1 2 3 NOT USED ON
THIS PRODUCT
