Exinda Network Orchestrator
3 Using
|
236
To configure a subnet for monitoring
Create a network object. See
For more information, refer to
.
I do not see my subnet data
If Network Object/Subnet statistics collection is disabled, the Subnets report will not include application data for the time
period the collection was disabled.
For more information, refer to
If the Subnet Report checkbox is not enabled on the definition of the subnet, then the data will not be included in the
report. If the data was collected, then enabling the Subnet Report will immediately show the data in the chart.
To change the throughput chart to stacked area charts or line charts
Press the down arrow next to the Stacked Chart button to select Line Chart to switch to the line chart. Conversely, press
the down arrow next to the Line Chart button to select Stacked Chart and switch to the stacked area chart. The line chart
shows the subnets against the common zero baseline so that the throughput of the subnets can be compared with one
another and the pattern of a specific subnet is clearer. You can look for particular patterns such as spikes or flat tops. If
your subnets are not defined to be mutually exclusive, displaying the throughput in a line chart with a common zero
baseline may make the most sense, as the cumulative values chart will double count some data and may not be
meaningful. However, if you have defined your subnets to be mutually exclusive then stacked area charts is an option.
To show the data volume of the subnets as a pie chart
Toggle on the pie chart by clicking the Pie button. Note that if your subnets are not defined to be mutually exclusive,
that is, data is captured in more than one subnet, then the pie chart does not hold much meaning.
To show more or fewer subnets in the top subnets chart and the throughput chart
The number of subnets shown are configurable. Note that this configuration applies to all charts on the appliance.
Should subnet totals match virtual circuit totals when the virtual circuit and subnet are based on the same
network object?
In general, yes. However, there are some cases where the traffic direction is different for subnets versus virtual circuits
and so the totals will not match.
For more information, refer to
Determining traffic direction and the implications of
Can I view the Top Internal or External Hosts per Subnet in this report?
By default, this report displays the Top Apps per subnet, but you can change the view to Top Internal or Top External
Hosts per Subnet. Click the drop-down arrow beside the Top Apps per Subnet button to view these other options. When
the display updates, the Top hosts data is mapped to a bar graph. You can brush over any host to view it's IP Address and
throughput data.
NOTE
Toggling the Top Internal Hosts per Subnet and Top External Hosts Per Subnet within this report is available in
version 7.0.3 and higher.
Summary of Contents for EXNV-10063
Page 369: ...Exinda Network Orchestrator 4 Settings 369 ...
Page 411: ...Exinda Network Orchestrator 4 Settings 411 Screenshot 168 P2P OverflowVirtualCircuit ...
Page 420: ...Exinda Network Orchestrator 4 Settings 420 Screenshot 175 Students OverflowVirtualCircuit ...