Exinda Network Orchestrator
4 Settings
|
457
NOTE
When the Trigger Threshold is reached, an alert notification is sent to the administrator. When the Clear Threshold
values are reached, the notifications stop being sent.
5.
Click
Apply Changes
.
4.2.9 Control Configuration
There are two Optimizer modes that affect the behaviour of how Optimizer policies are treated in a multi-bridge
deployments.
NOTE
To change Control Configuration, navigate to
Configuration > System > System Setup > Control Configuration
on the Web UI, advanced mode.
The form below is used to enable or disable Global Control:
Independent Control (Global Control disabled) (Default)
: Optimizer policies are applied to each bridge (LAN and WAN
pair) independently. For example, if there were a single policy to restrict all traffic to 1Mbps, this would be applied
independently to all bridges. So, the traffic through each bridge would not exceed 1Mbps.
Global Control (enabled)
: Optimizer policies are applied globally, to the entire system. For example, if there were a
single policy to restrict all traffic to 1Mbps, this would be applied across all bridges. So, the sum of all traffic through all
the bridges would not exceed 1Mbps. This is typically used when you are using multiple bridges and wish to QoS
everything as one link.
NOTE
Global Control cannot be enabled if Dynamic Virtual Circuits are in use.
In Clustering/HA deployments, Optimizer policies are implemented globally, so this setting only affects how traffic
through multiple bridges are treated. For example, a policy to restrict to 1Mbps on an Independent Control system
would allow 1Mbps through on each bridge, shared across all appliances (so all the Bridge 0's would share 1Mbps,
and all the Bridge 1's would share another 1Mbps, and so on for each bridge). A policy to restrict to 1Mbps on a
Global Control system would allow 1Mbps through system wide across all bridges on all appliances.
4.2.10 Disk storage explained
The Exinda appliance has the capability to dynamically change the amount of storage allocated to system services. The
Storage configuration page allows you to see how much disk storage is currently allocated to each system service, as well
as the amount currently in use. Users can re-size and reallocate disk space as required. The storage for particular services,
such as CIFS, Edge Cache, and WAN Memory, can be encrypted, if desired.
Summary of Contents for EXNV-10063
Page 369: ...Exinda Network Orchestrator 4 Settings 369 ...
Page 411: ...Exinda Network Orchestrator 4 Settings 411 Screenshot 168 P2P OverflowVirtualCircuit ...
Page 420: ...Exinda Network Orchestrator 4 Settings 420 Screenshot 175 Students OverflowVirtualCircuit ...
