Exinda Network Orchestrator
4 Settings
|
517
7.
To enter configuration mode, type
enable
then
configure terminal
. The prompt
exinda-appli-
ance (config) #
is displayed.
8.
To schedule the pre-population job type the following commands:
exinda-appliance (config) # job <job_number> command <command_number> "acceleration
prepopulate <prepopulation_name> start"
EXAMPLE
exinda-appliance (config) # job 100 command 1 “acceleration prepopulate
Documentation start”
exinda-appliance (config) # job 100 schedule daily time 00:30:00
4.5 Authentication
Learn the process of authenticating users and user groups on your network.
4.5.1 Display a List of Active Users
4.5.1 Display a List of Active Users
Active Users lists the users currently logged into either the Web UI or the CLI.
1.
On your browser, open the Exinda Web UI (
https://UI_IP_address
).
2.
Key-in the
User Name
and
Password
.
3.
Click
Login
. The Exinda Web UI appears.
5.
Click
Configuration > System > Authentication > Active Users
.
The table below shows an example of the currently logged in users along with the session type, IP address and the
session idle time in seconds.
4.5.2 Local User Accounts
Local User Accounts allows you to add/remove local user accounts as well as change local user's passwords.
Summary of Contents for EXNV-10063
Page 369: ...Exinda Network Orchestrator 4 Settings 369 ...
Page 411: ...Exinda Network Orchestrator 4 Settings 411 Screenshot 168 P2P OverflowVirtualCircuit ...
Page 420: ...Exinda Network Orchestrator 4 Settings 420 Screenshot 175 Students OverflowVirtualCircuit ...