background image

Loose Parts

Use the chart below to verify that all parts have been shipped.

Item

Part No.

Description

Qty

Item

Part No.

Description

Qty

1

116-9285

Asm-Tensioner Arm W/Bearing

1

9

116-9280

Damper-Mule Belt Drive

1

2

109-8754

Spacer

2

10

109-6658

Nut-Nyloc 3/8-16 Flg

5

3

109-8866

Bushing, Plastic

2

11

3231-31

Bolt-Carriage 3/8-16 x 2 1/2

2

4

104-8301

Nut-Nyloc 3/8-16 Flg

2

12

3231-5

Bolt-Carriage 3/8-16 x 1 3/4

1

5

323-12

Screw-HH 3/8-16 x 2 1/2

1

13

3231-7

Bolt-Carriage 3/8-16 x 2 1/4

1

6

116-6316

Spring-Extension

1

14

116-9359-03 Bracket-Damper Mnt Upper

1

7

116-0932

Dampener, Sleeve

1

15

323-6

Screw-HH 3/8-16 x 1

2

8

116-9300

Spacer

2

16

103-5858

Decal, Grease

1

Figure 2

2

Summary of Contents for 116-9360

Page 1: ... Black lettering Orange background Indicates a potentially hazardous situation which if not avoided Could result in death or serious injury CAUTION Black lettering Yellow background Indicates a potentially hazardous situation which if not avoided May result in minor or moderate injury This manual uses two other words to highlight information Important calls attention to special mechanical informat...

Page 2: ...6658 Nut Nyloc 3 8 16 Flg 5 3 109 8866 Bushing Plastic 2 11 3231 31 Bolt Carriage 3 8 16 x 2 1 2 2 4 104 8301 Nut Nyloc 3 8 16 Flg 2 12 3231 5 Bolt Carriage 3 8 16 x 1 3 4 1 5 323 12 Screw HH 3 8 16 x 2 1 2 1 13 3231 7 Bolt Carriage 3 8 16 x 2 1 4 1 6 116 6316 Spring Extension 1 14 116 9359 03 Bracket Damper Mnt Upper 1 7 116 0932 Dampener Sleeve 1 15 323 6 Screw HH 3 8 16 x 1 2 8 116 9300 Spacer ...

Page 3: ...g if in good condition remove and retain otherwise a new pulley and or bushing must be installed Discard all other mule drive components 9 Place the upper dampener mount bracket onto rear face of the engine mount bracket and align as shown in Figure 4 Mark the hole locations and drill two 406 inch diameter holes in the rear face of the engine mount bracket Attach the upper dampener mount bracket u...

Page 4: ...ive hours Self tensioning idler adjust as follows 1 Stop engine wait for all moving parts to stop and remove key Engage parking brake 2 On the left side of the engine deck support check the location of the bolt head in the center of the spring loaded pulley The top of the bolt should be at the bottom of the upper alignment hole as shown in Figure 6 It is necessary to adjust the belt tension when t...

Reviews: