Maintenance
Exmark Premium Hydro Oil is recommended.
Refer to the chart for an acceptable alternative:
Hydro Oil
Change Interval
Exmark Premium Hydro
Oil (Preferred)
250 Hours
Mobil 1 15W50
250 Hours
Torque plugs to 180 in-lb (244 N-m). Continue to
add Exmark Premium Hydro Oil until it reaches
the FULL COLD line on the expansion reservoir.
6. Raise the rear of machine up and support with
jack stands (or equivalent support) just high
enough to allow drive wheels to turn freely.
CAUTION
Raising the unit for service or maintenance
relying solely on mechanical or hydraulic
jacks could be dangerous. The mechanical or
hydraulic jacks may not be enough support
or may malfunction allowing the unit to fall,
which could cause injury.
Do Not rely solely on mechanical or hydraulic
jacks for support. Use adequate jack stands
or equivalent support.
7. Start engine and move throttle control ahead to
1/2 throttle position. Disengage parking brake.
WARNING
Engine must be running and drive wheels
must be turning so motion control adjustment
can be performed. Contact with moving parts
or hot surfaces may cause personal injury.
Keep fingers, hands, and clothing clear of
rotating components and hot surfaces.
A. With the engine running, slowly move the
directional control in both forward and
reverse directions (5 to 6 times). Check the oil
level, and add oil as required after stopping
the engine.
B. It may be necessary to repeat step A. until all
the air is completely purged from the system.
When the transaxle operates at normal noise
levels and moves smoothly forward and
reverse at normal speeds, then the transaxle
is considered purged.
Note:
Do Not
change the hydraulic system oil
(except for what can be drained when changing filter),
unless it is felt the oil has been contaminated or been
extremely hot.
Changing oil unnecessarily could damage hydraulic
system by introducing contaminants into the system.
Check Transmission
Output Shaft Nut Torque
Specification
Service Interval: After the first 5 hours
Yearly thereafter
Torque the nut on the transmission output tapered
shaft to 211-260 ft-lb (286-352 N-m).
Check Wheel Hub Nuts
Torque Specification
Service Interval: After the first 5 hours
Yearly thereafter
Torque the wheel hub nuts to 211-260 ft-lb (286-352
N-m).
Note:
Do Not
use anti-seize compound on the
wheel hub.
Check Wheel Lug Nuts
Torque Specification
Service Interval: Yearly
Torque the wheel lug nuts to 90-95 ft-lb (122-129
N-m).
Check Spark Arrester
(if equipped)
Service Interval: Every 50 hours
31
Summary of Contents for ARX481CKA30000
