5.1.2 Status of Outputs
This screen lists all of the outputs from the system
and highlights the one currently active. Outputs with
numerical values will display the current value.
g038556
Figure 9
1.
Status of outputs
3.
Clutch output
2.
Speed signal
4.
Engine power to run
•
Engine speed signal shows voltage signal sent
from the RED system to the engine ECU (Engine
Control Unit).
•
PTO output (highlights if ON)
•
Engine shutdown output (highlights if ON)
•
Module communication (highlights if LDU and
MCU are communicating)
•
Alarm (highlights if ON)
•
Starter (highlights if ON)
5.1.3 Current Error Messages
This screen displays the current error as text with
the non-resettable engine hours at which the error
occurred. The toggle button allows the user to scroll
between screens if multiple errors are active. If only
one error occurs, the toggle button will not change
screens.
g030185
Figure 10
1.
Current error
2.
Error display (e.g. Low oil pressure)
3.
Hour when it occurred
5.1.4 Hydraulic Transmission Oil Maintenance
This service reminder screen displays the hours until
the specified maintenance is due.
g030186
Figure 11
1.
Hydraulic trans oil
2.
Reminder display (e.g. Maintenance hours to service)
3.
Remaining hours until service is due
Press the toggle button to also display the
non-resettable engine hours at which every service
reminder reset was performed.
g030187
Figure 12
1.
Hydraulic trans oil
2.
Service history display
3.
Service reminder reset was performed (e.g. 250, 750)
5.1.5 Engine Oil Maintenance
This service reminder screen displays the hours until
the specified maintenance is due.
g030188
Figure 13
1.
Engine oil
2.
Reminder display (e.g. Maintenance hours to service)
3.
Remaining hours until service
9
