Operation
correct amount of gas stabilizer/conditioner to
the gas.
Note:
A fuel stabilizer/conditioner is most effective
when mixed with fresh gasoline. To minimize the
chance of varnish deposits in the fuel system, use fuel
stabilizer at all times.
Filling the Fuel Tank
Make sure the engine is shut off and the parking brake
is engaged. Tank maximum capacity is 2.9 gallons.
Note:
Use the fuel window to verify the presence of
gasoline before filling the tank.
Important:
Do Not overfill fuel tank. Fill the
fuel tank to the bottom of the filler neck. The
empty space in the tank allows the fuel to expand.
Overfilling may result in fuel leakage or damage
to the engine or emission system.
1. Shut the engine off and engage parking brake.
2. Clean around the fuel tank cap and remove the
cap (see Figure 9).
g027243
A
B
E
D
C
Figure 9
3. Add unleaded regular gasoline until the fuel
reaches the base of the filler neck and does not fill
the neck of the tank. This space at the base of
the filler neck allows gasoline to expand. Do Not
fill the fuel tank completely full. Overfilling may
result in fuel leakage or damage to the engine or
emissions system.
4. Install the fuel tank cap securely and tighten until
it “clicks”. Wipe up any gasoline that may have
spilled.
Checking the Engine Oil
Level
Before you start the engine and use the machine,
check the oil level in the engine crankcase; refer to
Checking the Oil Level
in Engine Maintenance
section.
Starting the Engine
1. Sit down on the seat, make sure the
traction-control pedal is in neutral and the parking
brake is engaged.
2. Disengage the blades by moving the blade control
switch to “OFF”.
Figure 10
Exmark Engine with 50 Inch Deck Shown
1.
Ignition
5.
Throttle lever
2.
Off
6.
Choke control
3.
Run
7.
Blade control switch–Off
position
4.
Start
3. Engage the choke before starting a cold engine
(if applicable).
Note:
A warm or hot engine may not require
choking.
4. Turn the ignition key to “START” to energize the
starter. When the engine starts, release the key.
24
Summary of Contents for QSS708GEM42200
