Operation
Adjusting the Anti-Scalp
Rollers
It is recommended to change the anti-scalp roller
position when the height of cut has changed.
1. Stop the machine and release the traction-control
pedal to place the machine in the neutral position.
2. Disengage the PTO.
3. Engage the park brake.
4. Stop the engine, remove the key and wait for all
moving parts to stop.
5. After adjusting the height of cut, adjust the
anti-scalp rollers by removing the nyloc nut.
6. Adjust the anti-scalp rollers for the normal
operating conditions. Place rollers in one of the
positions shown in Figure 14 or Figure 15. Rollers
will maintain 3/4 inches (19 mm) clearance to
the ground to minimize gouging and roller wear
or damage.
Note:
For Maximum Deck Flotation,
place
the rollers one hole position lower. Rollers should
maintain 1/4 inch (6.35 mm) clearance to the
ground. Do Not adjust rollers to support the
deck.
Figure 14
42 Inch Deck
1.
Anti-scalp roller mounting bracket
2.
Below 2 1/2 inches (64mm) cutting height
3.
2 1/2 inches (64mm) and above cutting height
Figure 15
50 Inch Deck
For cutting heights above 3 1/2 inches (90 mm)
use the bottom hole. The rollers will still be effective
against scalping.
1.
Anti-scalp roller
mounting bracket
2.
Cutting height
7. Torque hardware to 27-33 ft-lb (37-45 N-m) or
loss of roller may result.
Positioning the Seat
The seat can move forward and backward. Position
the seat where you have the best control of the
machine and are most comfortable.
Figure 16
Changing the Seat Ride
Suspension
The number of seat springs can be changed to
maximize rider comfort. More springs should be used
with heavier operators and on rough terrain. Fewer
29
Summary of Contents for QSS708GEM42200
