Operation
Note:
When changing the cutting height
positions, always come to a complete stop
and disengage the PTO.
g265194
Figure 11
1.
Deck lift handle
4.
Insert the height adjustment pin into the hole
corresponding to the desired cutting height.
See the decal on the top of the deck lift plate for
cut heights.
5.
Pull the deck lift handle rearward, depress the
release button and push slowly downward to
allow the deck to lower to the cutting height.
Adjusting the Anti-Scalp Rollers–
60 Inch Decks Only
It is recommended to change the anti-scalp roller
position when the height of cut has changed.
1.
Disengage the PTO.
2.
Bring the unit to a full stop.
3.
Make sure the motion control levers are in the
neutral position.
4.
Engage the parking brake.
5.
Stop the engine, remove the key and wait for all
moving parts to stop.
6.
After adjusting the height of cut, adjust the
anti-scalp rollers by removing the nyloc nut,
spring disc washer, and bolt.
7.
Adjust anti-scalp rollers for Normal Operating
Conditions. Place rollers in one of the positions
shown in Figure 12. Rollers will maintain 3/4
inches (19 mm) clearance to the ground to
minimize gouging and roller wear or damage.
Note:
For Maximum Deck Flotation
, place
rollers one hole position lower. Rollers should
maintain 1/4 inch (6.35 mm) clearance to ground.
Do Not adjust rollers to support the deck.
g281695
Figure 12
For cutting heights above 3.5 inches (38 mm) use the
bottom hole. The rollers will still be effective against
scalping.
1.
Anti-scalp roller
mounting bracket
2.
Cutting height
8.
Be sure roller bolts are installed with the spring
disc washer between head of the bolt and
mounting bracket (outer anti-scalp rollers only).
23
Summary of Contents for STARIS S Series
