Operation
WARNING
Caster or toe board weights installed without
the collection system may cause loss of
traction and steering control. Loss of control
can result in an accident which may cause
death, injury, or property damage.
Install caster or toe board weights ONLY
when the collection system is installed.
13.
The machine can now be used for side discharge
mowing.
Collection System Installation
Important:
Verify that the bagger mount
support brackets are installed on your unit prior
to operation.
1.
Stop engine, remove key, and wait for all moving
parts to stop. Engage parking brake.
2.
Remove hairpin and chute pivot pin. Remove
discharge deflector. Pivot pin and hair pin may be
stored in the pivot holes of the discharge deflector
during bagging operation.
3.
Lay the hopper assembly down as shown in
Figure 8.
g037114
Figure 8
1.
LH hopper mount bracket
2.
Frame notch
4.
Remove the hairpin from the mount pin and pull
the mount pin out of the frame mount barrel.
5.
Pick up the frame legs and hook the notch onto
the lower mount bar (see Figure 8).
6.
Lift the hopper assembly and pivot it upward
towards the back of the unit.
g037115
Figure 9
1.
Rotate hopper assembly
4.
Frame mount barrel
2.
Rear bumper
5.
Hairpin
3.
Mount bracket
6.
Mount pin
7.
Continue to push the hopper assembly forward
until it contacts the mount bracket.
8.
Install the mount pin into the frame mount barrel
(see Figure 9).
9.
Align the holes in the mount pin and frame mount
barrel and insert the hairpin to lock the hopper
assembly into place.
10.
Raise the hopper and install the bag assemblies by
inserting the hook portion into the slots in the
bagger support rods.
11.
Remove the belt cover on the right side of the
deck.
12.
Slip the belt over the impeller sheave on the
blower.
Note:
It may be easier to install the belt if the
belt guide is temporarily shifted to one side or
temporarily removed. Either loosen or remove
both nuts on the top and bottom of the belt guide.
Once the belt is installed on the impeller sheave,
reinstall the belt guide and tighten all hardware
(reference Figure 10).
13
Summary of Contents for ULTRAVAC BAGGER 126-6954
Page 21: ...Notes 21 ...
Page 22: ...Notes 22 ...
Page 23: ...Service Record Date Description of Work Done Service Done By 23 ...