Operation
g037432
Figure 14
1.
Blower
3.
Deck lip
2.
Belt cover
17.
Install the knob and its hardware (reference
Figure 5).
18.
Slip the upper and the lower tubes together.
19.
Insert the upper tube into the hopper seal –
push in then pull out so that the seal is extended
outward.
20.
Align the dimple on the upper tube with the end
of hopper seal and center between the two screws
as shown in Figure 15.
g007027
Figure 15
1.
Dimple
21.
Set the deck in lowest cutting position.
22.
Slide the lower tube onto the blower and attach
the latches. (Make sure that the upper tube does
not move out of alignment).
23.
If the lower tube is replaced, drill three 7/32 inch
holes in the lower tube using the upper tube holes
as reference. See Figure 16.
24.
Remove the tubes from unit and assemble the
upper and the lower tubes using three #10-24
x 3/4 inch hex washer head screws, three #10
washers, and three #10-24 nyloc nuts. The screw
head should be installed to the inside of the
tube to provide minimum obstruction to flow.
Make sure that the upper and the lower ends are
oriented properly as the tubes are assembled.
(Parting lines should roughly be lined up.)
g007028
Figure 16
1.
Drill the holes here
25.
Slide the lower end of the tube assembly over the
blower outlet and align the notch with the tube
latch. Latch the tube to the blower.
26.
On each side, install the ROPS pin into the hole
below the ROPS pivot.
27.
Install one removable caster weight on each caster
arm as shown in Figure 17.
g037183
Figure 17
1.
Bolt
3.
Washer
2.
Knob
4.
Caster weight
15
Summary of Contents for ULTRAVAC BAGGER 126-6954
Page 21: ...Notes 21 ...
Page 22: ...Notes 22 ...
Page 23: ...Service Record Date Description of Work Done Service Done By 23 ...