14
2.3.2 MANUALLY IGNITED SHOWS
The tracks of the RX2-Wave Player can be started via manual ignition signals (box- and
channelnumber). The following steps should be adhered to correctly control the receiver:
Preparing the RX2-Wave-Player
1
Set the RX2-Wave-Player to the preferred boxnumber (Recommendation is 50).
2
Correctly label the music tracks and save them to the SD-card.
3
Test playing the tracks with the transmitter.
4
Turn all receivers armed before the show starts.
5
Start the right track. Note: After a track has finished, the next one will start automatically.
6
Switch of the RX2-Wave-Players after the show.
The spare buttons of a TX2-70K can be a helpful support for shows, to start tracks simply and fast.
If needed, tracks can also be started using the receivers buttons.
2.3.3 AUTOMATICALLY IGNITED SHOWS (AUTOSHOW)
The following steps should be taken for a successful creation of a show with music from the RX2-
Wave Player:
2.3.3.1 SHOWCONCEPT AND PROGRAMMING THE RECEIVERS
As a first step, create the basic show concept. Check the following items:
1.) Which music and how many points or sound do I wish to use?
2.) How far away from the audience is the sound?
ADDING IGNITIONS
The track starts can be added via box- and channelnumber into the show. After a track has finished,
the next one will start automatically.
LOADING THE SHOW ONTO THE RECEIVERS
To transmit the show onto the receivers, please consult the manuel of the X2-series.
