5
1 ABOUT THE RX2-WAVE-PLAYER
1.1 FUNCTION OF THE RX2-WAVE-PLAYER
The RX2-Wave Player is a receiver, to be used to play music files (*.wav). It can be controlled via an
X2 transmitter and be started manually or automatically in a show.
Single music tracks can be saved onto the provided SD-card and be started by their respective box-
and channelnumber.
The musical output is done either via the 3.5mm stereo jack or XLR..
1.2 CONTROLLING THE RX2-WAVE-PLAYER
The RX2-Wave Player can be started via radio or manually.
When using radio control, use box and channelnumber, the same way as with other Explo receivers.
The following settings must be checked before using the device in a show:
1.2.1 BOXNUMBER
The Boxnumber is a general adressing of the receiver. It can be set from 0-99 and can be changed
either directly on the player, or via the transmitter.
It is recommended to use an own boxnumber for music receivers, to prevent faulty starting of the
music, while controlling other receivers.
1.2.2 CHANNELNUMBER / TRACKNAME
The channelnumber indicates which track is to be played. For the device to sort different tracks
correctly, these need to be labeled before saving them onto the SD-card with the preferred
channelnumber, like "01Trackname", "02Trackname", etc..
