8
2.1.3 DESCRIPTION OF COMPONENTS
2.1.3.1 BUTTONS
These buttons allow direct control of the player.They are used to navigate the menu, change settings
and manually starting the device without radio signals.
2.1.3.2 SD-SLOT
Houses the reader for SD-cards.
2.1.3.3 DISPLAY
Shows the receivers status as well as its menu structure.
2.1.3.4 RADIO STATUS LED
The red LED on the devices front gives you a feedback about radio signals. Should a signal be
received, the LED will flash once for ignitions or a testsignal in testmode, and three times for a test
signal during armed mode. When a track plays, it will be permanently lit.
2.1.3.5 ON-/ OFF SWITCH
This switch disconnects the power from the RX2-Wave Player. It must be activated (Position "I"), for
the player to be turned on via the activation button. To switch the player off, the switch must also be
turned to off (Position "O").
2.1.3.6 ACTIVATE BUTTON
After using the ON switch, this button can be pressed to start the device.
2.1.3.7 PROGRAMMING- AND CHARGING SOCKET
This socket allows you to charge the internal battery of the Player, or programm it with the newest
firmware update.
Buttons
Play / Pause
Stop
Back
Forward
