SUNSEEKER CONTROL PANEL
SWITCHES - AUX/VEH
When the switch is in the ‘veh’ position the
motorhomes’ 12-volt system is powered from
the vehicle battery. When it is in the ‘aux’
position it is powered from the motorhomes’
auxillary battery or the 12-volt charger/power
supply if the motorhome is connected to a 230-
volt supply.
It is recommended that the motorhome is used
in the ‘veh’ position sparingly as prolonged
use without running the engine could flatten
the vehicle battery.
LIGHTS
Switching either of these switches on (position
1) will cause some lights in the motorhome to
come on. Only those lights that are not
independently switched will come on.
AUX
Switching the ‘aux’ switch on (position 1) will
provide a 12-volt supply to the axillary socket
in the motorhome.
PUMP
The pump switch acts as a master switch for
the water system. When the switch is on the
water pump will provide water for the sink units
and shower on demand. Should the pump
keep cutting in and out during the night, then
turning the pump off will disconnect the 12-volt
supply to the pump.
As the toilet flush works independently of the
pump switch, the flush can still be used with
the pump switch in the off position.
INDICATOR LIGHTS
PUMP RUN
Adjacent to the pump switch is the ‘pump run’
indicator light. When the pump switch is on
and the pump is running this green light
should be on. When the pump is not running
the light should not be on.
WASTE FULL
On the right hand side of the panel is the
‘waste full’ indicator light. When the onboard
waste tank is becoming full and requires
emptying this red light will come on. Once the
tank is empty the light will go out.
MULTIFUNCTION DISPLAY
CLOCK
On initial power up the display will show the
time:- 0.00 and the ‘.’ will flash.
To reset the clock, press the button marked
‘mins’. This will advance the minutes. When
the minute before the one required is reached,
release the button. The clock will advance one
further minute. To set the hour repeat as for the
minutes using the ‘hrs’ button.
BATTERY VOLTAGE
When the ‘battery voltage’ button is pressed
the green LED light at the side of the button will
illuminate and the display will show the voltage
in volts.
CURRENT
Pressing the ‘current’ button will illuminate the
LED at the side of the current button and the
display will show the current taken on the 12-
volt circuits.
INSIDE TEMPERATURE
Pressing the ‘int temp’ button will cause the
LED to light at the side of the button and the
display will show the inside temperatures of
the vehicle, in degrees centigrade.
21
CONNECTING SERVICES - ELECTRICITY
Summary of Contents for 2003 Autostratus FB
