7. Clutch Outer/Driven Pulley
Disassembly
Remove drive belt, and driven pulley.
Install clutch spring compressor onto the
pulley assembly, and operate the compressor
to let the wrench be installed more easily.
Caution
Do not press the compressor too much.
Hold the clutch spring compressor onto bench
vise, and then remove mounting nut with
special service tool.
Release the clutch spring compressor and
remove movable driven sheave and spring
from driven pulley.
Remove seal collar from driven pulley
.
Remove guide pin, guide pin roller, and
movable driven face, and then remove O-ring
& oil seal seat from movable driven face.
Inspection Clutch outer
Measure the inner diameter of clutch outer.
Replace the clutch outer if exceed service
limit.
Service limit: 140.50 mm
Summary of Contents for Patriot 430
