FINAL ASSEMBLY
After adjusting tooth contact correctly, remove
the front and rear output shafts and drive bevel
gear.
Clean off any dye or paste from the gear teeth,
and lubricate the teeth with engine oil.
Tighten the drive bevel gear nut and rear out
put shaft nut to the specified torque.
Rear output shaft nut:100 N
᧪
M(10.0 kgf- m)
Drive bevel gear nut:100 N
᧪
M(10.0 kgf- m)
Stake the collar of the nut
Ⴜ
,A
into the notch in
the shaft.
NOTE:
After the tooth contact have been checked and
adjusted reassemble the joint.
Summary of Contents for Patriot 430
