14
QUARTZ
CLASSIC
10ºC
1ºC
100ºC
K5
K1
K2
SERVICE PROGRAMMING
Adjusting the boiler operating temperature
The boiler operating temperature is adjustable from 110ºC and 128ºC. To
adjust the boiler temperature, proceed as follows:
Set the machine to STANDBY mode by pressing the K3 and K5
buttons simultaneously for one second.
Press the K3 and K4 buttons simultaneously. The keypad will start to
flash to display the operating temperature of the boiler.
To determine the operating temperature, you must add all
buttons flashes together as explained below:
K5 represents one hundred degrees (one flash = 100ºC)
K1 represents ten degrees (one flash = 10ºC)
K2 represents single degrees (one flash = 1ºC)
Example: One K5 flash+one K1 flash+six K2 flashes= 116ºC
Press the K4 button to decrease the boiler temperature, or press
the K3 button to increase it. One button press equals one degree.
Switch the machine OFF and ON once to store the changes before using the
machine again.
Note:
• The temperature displayed represents the boiler temperature, not the temperature of the drink.
• The recommended boiler temperature is between 118ºC to 122ºC. (Default is 118ºC.)
i
K6
K3
K4
Summary of Contents for Quartz Classic One Touch
