6
•
Always remember to unplug the appliance before cleaning. Never unplug your appliance by pulling
on the power cable. Always grip plug firmly and pull straight out from the socket. Always check that
the plug and cable are undamaged.
•
All repairs must be carried out by qualified engineers. Inadequate repairs may be dangerous.
Never try to repair the refrigerator yourself.
•
Should the cover of the interior light or fan fall off or break, switch the refrigerator off immediately
and replace cover.
•
Ensure your chosen location has a flat and stable surface. The unit may be levelled by turning
either or both of the adjustable feet in the front corners. Check the unit is level using a spirit level.
•
Do not obstruct or cover the ventilation aperture.
•
Do not allow children to play with the appliance, or to sit on it or to hang onto the door(s).
BEFORE USING FOR THE FIRST TIME
Do not position this appliance with its rear panel directly against a wall. For good circulation and
operating efficiency, the ventilation grilles must never be blocked.
Remove all packaging (see page 2 for recycling information) and place the chiller on a stable, secure flat
surface. Position the chiller away from heat sources, where the unit is well-ventilated and protected from
moisture, or extremes of heat or cold. The refrigerator may not function properly if the temperature rises
above +30 °C (standard models). The refrigerator meets the operating conditions according to the
standard EN 441-4 in climate class 4.
A 10A fuse is fitted. Never replace with a fuse rated higher than this.
NEVER USE AN EXTENSION LEAD
. If the mains cable will not reach the nearest socket, either
rearrange your store layout or ask a qualified electrician to fit a new socket.
If power is cut off, wait for at least 5 minutes before plugging the unit in again to avoid damaging the
compressor.
Do not place combustible, explosive or volatile articles, corrosive acid or alkali, or liquid in glass
containers into the chiller. Always exercise caution if adjusting the temperature.
IMPORTANT: allow the refrigerator to stand upright for 8 hours before plugging in.
OPERATION
Place the shelves firmly on their supports. The maximum load for a shelf is 40kg. Check that the
refrigerator is functioning properly before installing and filling it. The thermostat or electronical
thermocontroller (option) is located inside the unit. An optional light switch is located inside the unit.
Never put warm or hot foods directly into the chiller.
ELECTRONIC THERMOCONTROL
The temperature has been pre-set at the factory between 0-10°C, dependent upon model. DO NOT
ADJUST THIS WITHIN THE FIRST 24HRS. After 24hrs have lapsed, adjust temperature in gradual
stages.
The temperature can be adjusted as follows:
•
Rotate the knob from 1 to cold to make it as colder as you can.
•
Just rotate the knob to the
“OFF” when you need to stop the showcase.
CLEANING
1. UNPLUG your chiller and remove any stock to a suitable back-up chiller.
2. Wash the inner compartment with warm water and neutral detergent. DO NOT allow the control
panel, cables or plug to get wet.
NEVER use corrosive detergents, wire brushes, or abrasive scourers to clean your chiller.
NEVER use metal or sharp implements to remove debris.
3. Dry all surfaces thoroughly
