English
16
17
English
Ideally, the flat side of the module (where the push button is situated) will be flush to the entry of
the ear canal after insertion. In this way, the device is fairly invisible and the sound optimal. There
are cases where the ear canal is too small: In that case, it is possible for the device to protrude a
few millimeters.
If the pull cord protrudes after the insertion of the device, after which it becomes visible, it can be
easily custom-cut by the dispenser.
Removing Q from the ear
Hold the pull cord firmly and pull it – always slowly – out of the ear.
Switching between programs
If the Q has been configured with more than one program (memories), the push button can be
used to select between various programs.
After the insertion of the battery the device is set by default to program 1. Just a short touch to the
push button will produce 2 beeps, indicating that program 2 has been switched on.
After another short touch to the push button, three beeps will be audible indicating that program
3 has been switched. A maximum of 4 programs can be set up. While program 4 is active, after
pressing the push button one beep becomes audible and the device sets back to program 1.
Fitting procedure and configuration
The fitting procedure and configuration of the hearing aid is both an important and individual
process. For this reason, consult your dispenser for any complaints about the fitting or configuration.
Your dispenser is the authorized person to carry out any necessary modifications.
Summary of Contents for Q
