11
EX-1113HMS
English
3. Layout, Connections & Jumper Settings
3.2 Connections
USB 3.2 Gen 1 B-Port:
D-
GND
StdB_SSTX -
Std
GND_DRAIN
St
StdB_SSTX -
D+
VBus
Attention!
Never plug in with force
or in wrong direction.
3.3 Jumper Settings
The EX-1113HMS will be delivered with the setting USB-Bus-Power.
But you have the possibility
to cut the power at the data line.
For this you open the case with the four screws on both sides.
Then you must set the jumper JP1 from ENA (Enable) to DIS (Disable). See the following picture.
JP1
ENA
DIS
© Copyright 2022 by EXSYS Vertriebs GmbH. All Rights Reserved
