RS-232/422/485/DIO to Ethernet Data Gateway
15
mask and Gateway address must be assigned
manually.
Socket port of HTTP
setup
If disable, then IP address, Subnet masks and
Gateway address must be assigned manually.
Socket port of serial
I/O
Port Number
：
：
：
：
any number between 1 and
65536,except 80 and 81
（
which have been
designated as the web pages, the default
value was set at 100
Socket Type
：
：
：
：
TCP Server, uses TCP protocol, passively
waits for Client.
TCP Client, uses TCP protocol, actively
connects to Server.
UDP
Client,
uses
UDP
protocol,
exchanges packets with Server without
connection.
Socket port of digital
I/O
This is an extra I/O socket with similar
configuration as the socket port of serial I/O,
but the Port Number must be different
Port Number
：
any number between 1 and
65536,except 80 and 81
（
which have been
designated as the web pages
）
, the default
number is 101.
Socket Type
：
：
：
：
TCP Server, uses TCP protocol, passively
waits for Client.
TCP Client, uses TCP protocol, actively
connects to Server.
UDP
Client,
uses
UDP
protocol,
exchanges packets with Server without
connection.
Destination IP address/
Socket port
（
（
（
（
TCP client
and UDP
）
）
）
）
Connection
The Server IP address under TCP client or UDP
client mode. It indicates which Server the unit
will connect to.
When set in “
Auto
” (default) mode, the
unit will builds the connection
automatically to the destination Server.
When set in “
Manual
” mode, the unit will
not build the connection to the
destination server except sending
