380900-EN v3.1 07/13
16
Battery and Fuse Installation
WARNING
: To avoid electric shock, disconnect the test leads from any source of voltage before
removing the battery cover.
1.
Turn power off and disconnect the test leads from
the meter.
2.
Remove the protective rubber holster.
3.
Open the rear battery and fuse cover by removing
the screw using a Phillips head screwdriver.
4.
Insert the battery into battery holder, observing the
correct polarity.
5.
For fuse replacement, gently remove the old fuse
and install the new fuse into the holder. Always
use a fuse of the proper size and value.
6.
Put the rear cover back in place. Secure with the
screw.
WARNING:
To avoid electric shock, do not operate the meter until the battery cover is in
place and fastened securely.
NOTE:
If your meter does not work properly, check the fuses and battery to make sure
that they are still good and that they are properly inserted.
