45170 –EU-EN-V1.2-5/11
3
Operation
Turn Power ON
Press the power button to turn power on. The meter will perform a short self-test.
A. Air
Velocity
Measurements
1. Press
the
Function
button to select the Anemometer mode. In Air Flow mode, the
display will show Air Velocity and Temperature.
2. Press
Unit/Zero
button to select desired unit of measure (FPM, MPH, KNOT, KM/H, or
M/S) and face the Air Flow Sensor towards the source of wind.
3. Allow time for the reading to stabilize and note value. From a practical point of view the
velocity may fluctuate slightly.
B. Humidity and Ambient Air Temperature Measurements
1. Press
the
Function
button to select RH mode.. In RH mode, the display will show %RH
and Temperature.
2. Press the °
C/°F
button to select the desired temperature unit of measure.
C. Temperature Measurements Using Type K Thermocouple
1. Press
the
Function
button to select the Temperature mode. In Temperature mode, the
display will show only temperature.
2. Plug the thermocouple into the meter's thermocouple input jack. If no thermocouple is
connected, or if the thermocouple is defective, the meter will display “
-----
“. (Primary
display temperature will only work if a thermocouple is connected).
D. Light Measurements
1. Press
the
Function
button to select the Light Meter mode . The light values are
displayed and orientated 180° from the other functions for easy use.
2. Press the
Lux/Ft-cd
to select Lux or Footcandle units of measure.
3. Before making measurements “Zero” the meter out by blocking the light sensor to
simulate a no light condition and pressing the
Unit/Zero
button.The reading should go
to Zero.
4. Hold the sensor toward the light source and note reading.
MIN, MAX, Data Recording Function
1. Press
the
Max/Min
button once. The RECORD symbol will appear on the display.This starts
the Min/Max Data Recording Mode
.
2. Press
the
Max/Min
again and the
MAX
symbol along with the maximum value will appear on
the display.
3. Press
the
Max/Min
once more and the
MIN
symbol along with the minimum value will
appear on the display.
4. To
Clear
the recorded Max/Min values press the
HOLD
button once. Press and Hold the
Max/Min
button for 3 seconds to exit Min/Max Data Record Mode and return to normal
measurement mode. Record and Max/Min will disappear from the display once this is done.