OUTPUT BUTTONS
Figure-5 Output Buttons
Slide Switch
Turn the slide switch to the position accordingly:
Figure-6 Slide Switch
3
(LEFT)/
4
(RIGHT):
Select which Digits or polarity to be adjusted
For voltage and current output, press this button momentarily to select which Digits
or polarity to be adjusted. The selected position will flash on the secondary display.
±
←→
D5
←→
D4
←→
D3
←→
D2
←→
D1
←→ ±
OUTPUT:
Press momentarily to toggle the
output state
ON
and
OFF
. The
means this signal has been sent out, and
means the signal has been disabled
output.
MODE:
Select output modes for CV (CC),
SCAN and RAMP.
Select Hz, %, pulse width and
Level adjustments for Square
wave output.
SHIFT:
Press to shift button operation
for INPUT (
OFF) or
OUTPUT (
ON)
:
Press and hold for more than 1
sec. to toggle backlit ON/OFF
5
(UP)/
6
(DOWN):
Adjust digit or polarity
Press momentarily to increase/
decrease 1 count for present digit or
toggle the polarity of output state.
M/S:
Provide power for
Measuring and Source
function.
M:
Provide power for
Meter (INPUT) only.
Charge:
Charge batteries
by using the standard DC
adapter
Slide Switch
Charging indication
Green: Fully charged
Red: Under charged
External DC adaptor
jack:
Plug in the external DC
adapter to charge the
batteries or to power the
device.
