CFI EXTEL WESVDD 82700 - 06/2009 - V1
11EN
recording following motion detection
: Your video changes into “alarm system”, you select a
detection area in the image, any intrusion in this area will trigger the recording sequence with, if
selected, a beep.
•
Motion detection: activate the motion detection function, by pressing « OK ».
.
•
MD Setup: setting the detection sensitivity and the definition of the motion area on the image
Sensitivity:
setting the detection sensitivity from 1 (less sensible) to 8 (more sensible).
« OK », with the «
pq
» keys select the sensitivity.
Validate and exit with the « OK » key, exit without activating the function with the « SETUP »
key.
Area Setting
: definition of the detection area
Go with the «
q
» key to « Area Setting », « OK ». A red frame appears on the image.
You can reduce the upper part and the left part with the keys «
pqtu
» of the remote control unit.
Press « DEL » on the remote control unit, the frame becomes yellow, you can move it in your
screen with the «
pqtu
» keys.
« OK » to validate and return to the sub-menu or exit without modifying the area with the «
SETUP » key.
Press the « SETUP » key of the remote control unit, select with the «
pq
» keys
« RECORDER SETTING », « OK ».
Use the «
u
» key to go to the box « ON ».
Validate and exit with the « OK » key, exit without activating the function with
the « SETUP » key.
Once activated, the function is immediately operational, the detection function is
only active on the camera visible on the screen. (In stop position the function is
operational only in the « schedule » function).
