3 4
1 2
3
4
6 5
1
2
15 V
WEVP 630 E BIS WIRING
3
4
6 5
1
2
12 V
*
*
CATCh OR LOCK FUNCTION
3
4
6 5
1
2
15 V
or
MECHANISM
12 V catch or lock
The key on the monitor results in a
current-free contact, like a push button
Refer to your mechanism's instructions
for connection of the control unit
* Optional components
which are not supplied
5EN
b. Connection of an electric catch or lock
If the installation is to include an electric catch or lock, two more wires will have to be added to connect the
catch or lock to the monitor.
Connect them to terminals 5 and 6 of the monitor.
NB: the power supply to the electric catch or lock is to be provided by an independent transformer which is
not supplied in the kit (Extel ref.: WETR 14602).
NB: this function can only be used if the monitor is connected to a power supply.
a. Installation of the oudoor station (camera)
1. Remove the two screw covers using a small screwdriver lodged in the notch . Remove the two
screws.
2. Insert the plastic casing taking care not to obstruct the plate fixation holes.
3. Connect the cable as shown in the wiring diagram with the waterproof gasket in place.
4. Screw the plate onto the inserted casing using the two screws .
5. Put the two screw covers back.
Make sure that the camera lens is not pointing directly at the sun or at a reflective surface.
c. Connection of a gate mechanism
Connect it directly to terminals 5 and 6 on the back of the monitor. The monitor provides a current-free “dry”
contact on your mechanism's “push button” function.
NB: this function can only be used if the monitor is connected to a power supply
4. INSTALLATION
Summary of Contents for WEVP 630 E BIS
Page 1: ......