7
4-3 Thread of strap
[Procedures]
Step [1]
Place the reel onto the rail and push in the
Reel, until the reel shaft falls into the reel slot.
Caution:
When putting the reel onto the rail,
Set it in such a way that the strap
End comes out up the reel.
Step [2]
Please install the P.P. strap through the brake roller (1)
Then refer to the draft for installing the p.p. strap through
The free Roller (2) and press the lever (4) and insert the
Strap into the entrance (3) till it reaches the pool roller.
Caution: If the strap end is split or bend, strap may
Catch and block the machine side.
At this time you should cut the strap end,
Then try to thread the strap again.
Step [3]
Press the start button and the strap is sent to the arch Automatically.
Step [4]
Press the start button and the strap is sent to the arch
[NOTE]
If the strap is not set to the arch properly, the strap is discharged out of the strapping
Automatically.
Check the strap end, if the strap end is split or bent cut it and reap the procedures for
Threading the strap into the entrance.
Chapter 5 Operation
Reel
Reel
Rail
