50
manual
In order to attach the lining, the hung-profile
is screwed to the inside of the pool at 20cm
intervals . (stainless steel screws 4x30mm)
Ensure walls are dust-free to avoid irregu-
larities in the liner .
Glue the fleece in place under the hung
profile and glue onto the walls .
Press the felt nicely for an even attach-
ment .
2.3 Interior finish
Mark the opening of the return (2x) and
remove the piece with a drill .
Stick the seal on the wall and push the
return (2x) through the opening . On the
outside, tighten the return until it is secu-
rely in place .
Now you must place the coupling and
connect it to the tap via a hose (see
technical section: 2 .4 .3 Connections) so
that the bath can be further filled .
1
2
3
4
Liner overhoeks in
het hungprofiel plaatsen
1
2
3
4
Poser le liner diagonalement
au profil hung
1
2
3
4
Put the liner diagonally
in the hung-profile
The position of the liner needs to be
100% correct and the liner should have
min . 18°C so that there is sufficient
elasticity . An opening must be cut for the
skimmer and the water return device .
tIp
: Store the liner some days in advance
at room temperature .
You can tape the corners of the pool in
order to prevent folds in the liner . Unfold
the liner in such a way that the corners
of the liner correspond with the corners
of the pool .
Slide the edge of the liner into the Hung-
profiles, ensuring that the corners of the
liner match up well below .
If you want to include an underwater light, you must first drill the hole (25 mm dia .) for the connector to guide the cable out of the pool .
Determine the position, preferably 70 cm (28 in) below the border edge, and in the middle of a plank .
The pool can now be filled with a few inches of tap water . On bare feet and using a
plastic squeegee, remove the folds in the liner and press the liner well into the cor-
ners of the pool . Before making the incision into the liner for the skimmer hole, fill the
pool to a few inches below the position of the water return opening . Please follow the
illustrations included in the skimmer and water return’s packaging . During the filling of
the swimming pool the wood structure on the outside should be filled in gradually .
