25
ENGLISH
ventIlatIOn
This menu allows to enable or disable the operation of the tangential motor and to adjust the speed (-2, -1, 0, +1, +2) of the front fan.
The
seT TherMosTaT
allows to set the room temperature to be reached (front ventilation must be active).
once the temperature set in
seT TeMPeraTUre
has been reached, the ventilation will turn oFF and then it will turn back on when required.
Range: 07 - 37°c.
enABlIng conTRolS pRoceduRe
OK >VeNTILaTION> eNaBLINg > SeT
Speed conTRolS pRoceduRe
OK >VeNTILaTION> SpeeD > SeT
SeT THeRMoSTAT conTRolS pRoceduRe
OK >VeNTILaTION> SeT ThermOSTaT > SeT
easy setUp
The volumetric weight of the pellet is the ratio between the weight and the volume of the pellet. This ratio may change without altering
pellet quality. By using the eASY SeTup function, it is possible to change the calibration of the volumetric weight by increasing or decreasing
the preset values.
In the stove program, the available values range from “– 3” to “+ 3”; all stoves are calibrated during production with the optimal value which
is 0
If you notice an excessive deposit on the burn pot, access the eASY SeTup program and lower the value by one unit to “- 1”; then wait until
the next day and if there is no improvement, decrease again, to a maximum of “- 3”. Instead, if it is necessary to increase the calibration of the
volumetric weight of the pellet, change the factory value from “0” to “+ 1, + 2, + 3” as required.
To set:
OK > eaSy SeTUp
eXcessive PelleT dePosiT in BUrn PoT
norMal oPeraTion
MiniMUM PelleT dePosiT in BUrn PoT
-3
-2
-1
0
+1
+2
+3
THIRd decReASe
RAnge IF THe
FIRST TWo ARe
InSuFFIcIenT
Second
decReASe
RAnge IF
THe FIRST IS
InSuFFIcIenT
FIRST decReASe
RAnge (TeST FoR
1 dAY)
opTIMAl FAcToRY
vAlue
FIRST IncReASe
RAnge
Second
IncReASe RAnge
IF THe FIRST IS
InSuFFIcIenT
THIRd IncReASe
RAnge IF THe
FIRST TWo ARe
InSuFFIcIenT
n.B.: iF These adJUsTMenTs do noT solve The ProBleM oF PelleT dePosiTs in The BUrn PoT, Please conTacT yoUr local
service cenTre.
Summary of Contents for 001282105
Page 2: ...2 ENGLISH APPLY TECHNICAL DATA LABEL ...
Page 37: ...37 ENGLISH ...
Page 38: ...38 ENGLISH ...
Page 39: ...39 ENGLISH ...
