TA
ENGLISH
Ducting featuRes
The AnASTASIA PLUS model is fitted with two independent ducting outlets.
Ducts Z1 - Z2 are activated by default.
Features:
diameter of ducting outlet: 2x80 mm
maximum recommended ducting length 8m
temperature controlled ducting
regulation of air flow speed as a percentage
independent ducting that can be activated/deactivated (On-OFF)
Z2 ducting
Z1 ducting
factoRy Default Ducting opeRation
Ducting Z1 and Z2 are always in request by default (bridges on Z1 and Z2) and follow the stove settings.
- no settings necessary.
Z1 moDe
set to
on
:
Set the
set Zone Z1
to
off.
•
Until the desired temperature is reached (closed contact) the ducting motor will follow
the stove settings.
•
When the temperature set on the thermostat is reached (open contact), the ducting
motor will switch to the 1st speed.
Z1 moDe
set to
eco
:
Set the
set Zone Z1
to
off.
•
Until the desired temperature is reached (closed contact) the ducting motor will follow
the stove settings.
•
When the temperature set on the thermostat is reached (open contact), the ducting motor
will turn off, and then turn on again when required.
Same SettingS for Z2 ducting
Ducting opeRation with theRmostat oR pRoBe (optional)
The stove is fitted with two independent motors for ducting. The connection of an external thermostat or temperature probe (nTC 10K) in
inputs Z1 and Z2, located in the rear part of the stove, makes it possible to control the ducting motor independently of the stove.
Suffice it to connect the thermostat/temperature probe and set the desired temperature.
For information on ducting settings see chapter:"
menu - ducting
"
with Room theRmostat (optional)
Remove the bridge on Z1 and attach the room thermostat in the room where you wish to control the temperature through Z1 ducting.
two operating modes:
10
Summary of Contents for ANASTASIA PLUS
Page 2: ...ENGLISH 2 ...
Page 26: ...A B C E E E F F D F D D ENGLISH on applicable models 26 ...
Page 34: ...ENGLISH 34 ...
Page 35: ...ENGLISH 35 ...
