15
ENGLISH
tHe remote Control
all that can normally be implemented through the lCD can be adjusted using the remote control.
The table below provides a detailed description of the various functions:
INFO
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
1
on / off
pressing the key for three seconds, the stove will switch on or off
2
power inCrease
pressing the key will increase the operating power
3
power DeCrease
pressing the key will decrease the operating power
4
t° inCrease
The temperature setting can be increased by pressing this key
5
t° DeCrease
The set temperature can be decreased by pressing this key
6
enable / Disable
CHrono
pressing the key once will enable or disable the chrono
7
enable DelayeD
switCH-off
The delayed switch-off can be set by pressing this key.
For example, if the stove is set to switch-off in an hour, it shall switch-off
automatically once the set time elapses, displaying the countdown every
minute for delayed automatic shutdown.
8
menu
This key allows the user to access the user and technical menu (the
technical menu is reserved for assistance)
9
inCrease
The temperature setting can be increased by pressing this key
10 esC key
The key allows the user to exit any program or display and returns to the
main menu without saving the data
11 baCk
The key returns to the display of the various menus
12 Confirmation key
This key confirms the adjustments made during the user menu
programming phase
13 forwarD
The key allows the user to go forward in the various menus
14 enable funCtion f1
pre-set key for future applications
15 DeCrease
The key decreases the value to be set
16 stove status
pressing this key will display the general status of the stove
type anD replaCement of batteries
The batteries are housed in the lower part of the remote control.
To replace it, you need to take out the battery holder, remove or insert the battery following the symbols on the remote control and on the
battery.
For operation, 1 Cr2025, 3v lithium buffer battery is required.
The batteries used contain metals harmful for the environment. They must therefore be disposed of separately in appropriate containers.
important note: the numbers shown on the remote control are purely indicative and are not present on the remote control supplied with the product.
if tHe remote Control is off beCause it Has no batteries, tHe stove Can be ControlleD from tHe Control
panel on top of it. wHile replaCinG tHe battery, pay attention to tHe polarity by observinG tHe symbol on
tHe insiDe Compartment of tHe remote Control.
J
all Clean CHeCk up
sHoulD tHe "all Clean CHeCk up" alarm be triGGereD, make sure
tHat tHe bottom of tHe burn pot is free of resiDues or sCales.
tHe Holes at tHe bottom must be Completely free to Guarantee
CorreCt Combustion. one Can use tHe funCtion to aDjust
Combustion baseD on tHe DesCribeD requirements. if tHe alarm
persists anD tHe above listeD ConDitions Have been CHeCkeD,
ContaCt tHe qualifieD after-sales assistanCe Centre.
BUrN pOT HOles
Summary of Contents for DIADEMA ACS IDRO
