2
4. Connect the velcro on roof corners to the
velcro on the corners of the canopy legs.
8. Lift all four roof connectors until pin locks
into position. Stand on foot plate and lift with
two hands, you will hear a ‘Click’.
7. Ensure there are not trip hazards. Walk
backwards and open frame fully.
11. Extend back legs, repeat step 10.
Once tent is set-up
REFER TO SECURING
YOUR CANOPY ON PAGE 3.
2. Open frame 75% of full extension.
1. Remove all your items from packaging and
clear a safe area.
5. Fit the peak of the roof to the center pole/s
of the canopy, tighten the toggle.
9. Ensure protective flap is over the truss
connector, this will protective roof from wear.
Attach roof straps by looping straps around
frame and engaging clip. Tighten the strap.
3. Fit the roof to the frame.
6. Refer to LIFT HERE sticker. Grasp canopy
truss bars.
10. Extending the front canopy legs. Using
one foot stand on the canopy foot plate,
release the button on the middle leg
connector and extend front legs to desired
height.
10’ X 20’ CANOPY SETUP
REFER TO PAGE 3 >>
SET- UP INSTRUCTIONS
Please read instructions completely before setting up your tent. Make sure you have all the parts identified on the Parts List.
