Extreme Flight slick 580 exp, Assembly Instructions Manual

Use two6” (150mm) servo extensions for the ai-

leron leads inside the fuselage. Your Slick includes 

these mounting locations for the female servo con-

nectors. 

Install an Extreme Flight RC fuel dot as shown into 

the fuselage side.

This is a typical overflow vent outlet location on the 

bottom of the fuselage.

Measure the location of the exhaust outlets from 

the firewall. Transfer this dimension to the bottom 

of the cowl and cut the required openings. We use a 

Dremel tool for this job - protect your eyes and lungs 

from dust.

Working slowly, checking fit often, enlarge the open-

ings until the cowl slides smoothly on and every-

thing has clearance. Note that we have shown the 

minimum amount of opening, which is fine for cool 

weather. During the hot Summer, your engine may 

need more cooling air

13

Mount your receiver, and tie all wires to prevent 

vibration damage. 

For electric power, use strong velcro straps to re-

strain the lipo battery packs as shown. 

For electric power, open the vents on the bottom of 

the fuselage as shown.