Wall Mount Procedure
Altitude™ 4522 Series Access Point Installation Guide
15
4
If required, install and attach a Kensington security cable (customer supplied) to the
unit’s lock port.
5
Attach an Ethernet cable from the Access Point to a controller with an 802.3af-compatible
power source or use the PWRS-14000-148R power supply to supply power to the
Altitude 4522 Access Point (once fully cabled).
6
Place the middle of each of the case’s mount slots over the screw heads.
7
Slide the case down along the mounting surface to hang the mount slots on the screw
heads.
8
Verify that the unit has power by observing that the LEDs are lit or flashing.
CAUTION
If you are not using a 802.3af capable controller to power the Altitude 4522 Access Point,
ensure that only the Altitude 4522 Access Point’s designated power supply (PWRS-14000-148R) is
used. Using an incorrectly rated power supply could damage the unit and void the product warranty.
Do not actually connect to the power source until the cabling portion of the installation is complete.
Summary of Contents for Altitude 4522 Series
Page 68: ......
