Altitude™ 4522 Series Access Point Installation Guide
33
10
Select an
Access Point Type
from the following options:
●
Virtual Controller AP
- When more than one Access Point is deployed, a single Access
Point can function as a Virtual Controller AP. Up to 24 Access Points can be
connected to, and managed by, a single Virtual Controller AP of the same Altitude
4522 Access Point model.
●
Standalone AP -
Select this option to deploy this Access Point as an autonomous fat
Access Point. A Standalone AP isn't managed by a Virtual Controller AP, or adopted
by a controller.
NOTE
If you are designating the Access Point as a Standalone AP, Extreme Networks
recommends that the Access Point’s UI, and not the CLI, be used exclusively to define its device
configuration. The CLI provides the ability to define more than one profile and the UI does not.
Consequently, the two interfaces cannot be used collectively to manage profiles without an
administrator encountering problems.
●
Adopted to Controller
- Select this option when deploying the Access Point as a controller
managed (Dependent mode) Access Point. Selecting this option closes the Initial AP
Setup Wizard. An adopted Access Point obtains its configuration from a profile stored
on its managing controller. Any manual configuration changes are overwritten by the
controller upon reboot.
Select the
Automatic controller discovery
option to enable the Access Point to be discovered
and adopted using layer 2 settings. If you prefer layer 3 adoption, select the
Static
Controller Configuration
option, and define the addresses of the preferred controllers.
Summary of Contents for Altitude 4522 Series
Page 68: ......
