Procedure
1. Attach one end of the KT-150173-01 extension arm to the access point using two M6 hex-head
screws.
2. Attach the KT-147407-02 pole part to the other end of the KT-150173-01 bracket using two hex-head
M12 stainless-steel screws, and two hex-head M12 stainless-steel nuts.
3.
Attach the pole bracket to the pole
.
Attach the Access Point to a Pole Using the KT-147407-02 Bracket Parts and the
KT-150173-01 Extension Arm
Before You Begin
You can attach the access point to a pole using all the parts of the KT-147407-02 bracket and the
KT-150173-01 extension arm.
The following hardware is required:
•
KT-147407-02 flat part
•
KT-147407-02 1-axis tilt part
•
KT-147407-02 pole part
•
KT-150173-01 extension arm
•
Six M6 hex-head screws
•
Four hex-head M12 stainless-steel screws and nuts
•
Two 0.5 in. (12.7 mm) wide stainless-steel cable clamps
•
Access point
About This Task
To install the access point on a pole:
Procedure
1. Attach the KT-147407-02 flat part to the access point.
For instructions on how to attach the bracket parts, see
Install the Access Point to a Flat Surface
Using KT-147407-02 Flat Part and 1-Axis Tilt Part
.
Install the Access Point
Attach the Access Point to a Pole Using the
KT-147407-02 Bracket Parts and the KT-150173-01
Extension Arm
ExtremeWireless™ AP460i/e Access Points
33
