Figure 6: KT-147407-02 bracket 1-axis tilt part
Note
The flat part and the 1-axis tilt part can be used interchangeably with the access points. You
can either attach the flat part or the 1-axis tilt part first, and the rest of the installation
procedure will not be affected by it.
The following hardware is required:
•
KT-147407-02 flat part
•
KT-147407-02 1-axis tilt part
•
Access point
•
Ten M6 hex-head screws
◦
Two M6 screws to attach the KT-147407-02 flat part to the access point
◦
Four M6 screws to attach the KT-147407-02 1-axis tilt part to a flat surface
◦
Four M6 screws to attach the KT-147407-02 flat part to the 1-axis tilt part
Procedure
1. Using two M6 hex-head screws, attach the KT-147407-02 flat part to the access point.
2. Using the 1-axis tilt part as a template, mark and drill four holes on a wall or a flat surface.
3. Using four M6 screws, attach the 1-axis tilt part to a wall or a flat surface.
4. Align the KT-147407-02 flat part bracket inside the 1-axis tilt part, and attach it using four M6 screws.
5. Tilt the access point to a desired angle and tighten the four M6 screws to a torque of 45 in-lbs.
The tilt bracket can be adjusted from +15 degrees to –15 degrees of tilt.
Install the Access Point to a Flat Surface Using the KT-147407-02 Flat Part, 1-axis Tilt
Part, and the KT- 150173-01 Extension Arm
Before You Begin
The KT-150173-01 extension arm is used to install the access point on a flat surface, away from any
obstruction and to get a stronger antenna signal. For installations that require an extension arm, the
access point can be attached to a flat surface using the KT-147407-02 bracket parts and the
KT-150173-01 extension arm, or
can be installed by only using the KT-150173-01 extension arm
Install the Access Point to a Flat Surface Using the
KT-147407-02 Flat Part, 1-axis Tilt Part, and the KT-
150173-01 Extension Arm
Install the Access Point
20
ExtremeWireless™ AP460i/e Access Points
