configure snmp add trapreceiver
ExtremeWare 7.5 Command Reference Guide
131
1
This SNMP trap group is only available on the “
i
” series of switches.
To view the SNMP trap receivers configured on the switch, use the
show management
command. The
show management
command displays information about the switch including the destination and
community of the SNMP trap receivers configured on the switch.
To restore defaults to all SNMP-related entries, including the SNMP parameters modified using the
configure snmp add trapreceiver
command, use the
unconfigure management
command.
For version 7.1 and higher:
•
Only the trap groups specified will be sent to the receiver.
ExtremeWare 7.1 introduced support for SNMPv3, and the concept of trap groups was added to
allow SNMPv1/v2c users to access a simplified version of the capabilities of SNMPv3. ExtremeWare
7.2e added the same function for the Summit “
e
” series of switches. The trap groups are pre-defined
and cannot be modified. See chapter 3, “Managing the Switch”, in the
ExtremeWare User Guide
for
more detail about trap groups.
For version 6.0 and higher:
•
A maximum of sixteen trap receivers can be configured for each switch.
For version 4.x:
•
A maximum of six trap receivers can be configured for each switch.
system-traps
extremeOverheat
extremeFanFailed
extremeFanOK
extremePowerSupplyFail
extremePowerSupplyGood
extremeModuleStateChange
extremeHealthCheckFailed
extremeCpuUtilizationRisingTrap
extremeCpuUtilizationFallingTrap
coldStart
warmStart
1.3.6.1.4.1.1916.0.6
1.3.6.1.4.1.1916.0.7
1.3.6.1.4.1.1916.0.8
1.3.6.1.4.1.1916.0.10
1.3.6.1.4.1.1916.0.11
1.3.6.1.4.1.1916.0.15
1.3.6.1.4.1.1916.4.1.0.1
1.3.6.1.4.1.1916.4.1.0.2
1.3.6.1.4.1.1916.4.1.0.3
1.3.6.1.6.3.1.1.5.1
1.3.6.1.6.3.1.1.5.2
extreme-traps
extremeEsrpStateChange
extremeEdpNeighborAdded
extremeEdpNeighborRemoved
extremeSlbUnitAdded
extremeSlbUnitRemoved
1.3.6.1.4.1.1916.0.17
1.3.6.1.4.1.1916.0.20
1.3.6.1.4.1.1916.0.21
1.3.6.1.4.1.1916.0.18
1.3.6.1.4.1.1916.0.19
smart-traps
extremeSmartTrap
1.3.6.1.4.1.1916.0.14
auth-traps
AuthenticationFailure
extremeInvalidLoginAttempt
1.3.6.1.6.3.1.1.5.5
1.3.6.1.4.1.1916.0.9
link-up-down-traps
linkDown
linkUp
1.3.6.1.6.3.1.1.5.3
1.3.6.1.6.3.1.1.5.4
rmon-traps
risingAlarm
fallingAlarm
rmon-traps, 1.3.6.1.2.1.16.0
security-traps
extremeMacLimitExceeded
extremeUnauthorizedPortForMacDetected
extremeMacDetectedOnLockedPort
extremeNetloginUserLogin
extremeNetloginUserLogout
extremeNetloginAuthFailure
1.3.6.1.4.1.1916.4.3.0.1
1.3.6.1.4.1.1916.4.3.0.2
1.3.6.1.4.1.1916.4.3.0.3
1.3.6.1.4.1.1916.4.3.0.4
1.3.6.1.4.1.1916.4.3.0.5
1.3.6.1.4.1.1916.4.3.0.6
Table 7:
SNMP Trap Groups (Continued)
Trap Group
Notifications
MIB Subtree
Summary of Contents for ExtremeWare 7.5
