ipe-2200ax-T and ipe-2200ax-F – Installation in a Rack
Installing the Outer Rails onto the Rack
Each end of the assembled outer rail includes a bracket with square pegs to fit into your rack holes.
If you have an older rack with round holes, these brackets must be removed, and you must use
screws to secure the rail to the rack.
1.
Align the square pegs on the front end of the rail with the square holes on the front of the rack
(C). Push the rail into the rack until the quick release bracket snaps into place, securing the rail
to the rack. Keep the rail horizontal.
2.
Adjust the rail to reach the full depth of your rack.
3.
Align the square pegs on the rear end of the rail to the holes on the rack (D) and push the rail
into the rack until the quick release bracket snaps into place, securing the rail to the rack.
4.
Repeat the procedure for the other outer rail assembly.
Note
: the figure above is for illustrative purposes only. Always install servers at the bottom of the
rack first.
Sliding the appliance onto the Rack Rails
1.
Align the chassis rails with the front of the rack rails.
2.
Slide the chassis rails into the rack rails, keeping the pressure even on both sides. The spring
latch engages when the chassis is part way in. Push the appliance completely into the rack.
3.
Insert and tighten the thumbscrews that hold the front of the appliance to the rack.
