Battery Replacement and Disposal
Summit X430 Series Switches Installation Note
6
●
Never look at the transmit LED/laser through a magnifying device while the laser is powered on.
●
Never look directly at a fiber port on the switch or at the ends of a fiber cable when they are
powered on.
●
Invisible laser radiation can occur when the connectors are open. Avoid direct eye exposure to the
beam when optical connections are unplugged.
●
Never alter, modify, or change an optical device in any way other than suggested in this
document.
Battery Replacement and Disposal
Batteries included with Extreme products are encapsulated and must be replaced only by qualified
Extreme Service personnel. Contact your Extreme Networks Service personnel for product replacement.
Do not attempt to replace the battery. If these instructions are disregarded and replacement of these
batteries is attempted, the following guidelines must be followed to avoid danger of explosion:
●
Replace with the same or equivalent battery type as recommended by the battery manufacturer.
●
Dispose of the battery in accordance with the battery manufacturer’s recommendation.
Battery Warning — Taiwan
WARNING!
Fiber Optic Ports and Optical Safety
The following safety warnings apply to all optical devices used in Extreme Networks equipment that
are removable or directly installed in an I/O module or chassis system. Such devices include but are not
limited to gigabit interface converters (GBICs), small form factor pluggable (SFP) modules (or
mini-GBICs), QSFP+ modules, XENPAK transceivers, and XFP laser optic modules.
